Cymbol G3 Series Guide de l'utilisateur télécharger pdf (Page 65)

3.8 Resetting to the factory default settings

To reset the Network Camera to the original factory settings, go to the Setup>System >Maintenance

web page (described in “3.5.6 System>Maintenance” of the User’s Manual) or use the Reset button on

the network camera, as described below:

Follow the instructions below to reset the Network Camera to the factory default settings using the

Reset button.

•

Using the Reset Button

Follow the instructions below to reset the Network Camera to the factory default settings using

the Reset button.

1. Switch off the Network Camera by disconnecting the power adapter.

2. Press and hold the Reset button while reconnecting the power.

3. Keep the Reset button pressed during about 2 seconds or more than.

4. Release the Reset button.

5. The network camera resets to factory defaults and restarts after completing the factory

reset.

Caution: When performing a Factory Reset, you will lose any settings you have saved.

(Default IP 192.168.30.220)

1 2 ... 60 61 62 63 64 65 66 67 68 69 70

Pas de commentaire

Cymbol G3 Series Guide de l'utilisateur Page 65